Mitsubishi MELSEC-A A2ASCPU-S1 User Manual

App - 48
APPENDIX
(d) For A2ASCPU,A2ASCPU-S1
(2) The compatibility of the conventional products (existing system products) and the
new products (AnU-compatible products) is listed in the following table.
(a) For A2USHCPU-S1
Model name of
the peripheral
device
Model name of the software package Applicability Applicable range
PLC model name
at start-up
A6GPP/A6PHP
SW4GP-GPPA Usable Device range of A2ACPU A2A
SW3GP-GPPA Usable Device range of A3HCPU A3H
SW2 type or earlier Not usable
––
A6HGP
SW3-HGPA Usable Device range of A3HCPU A3H
SW2 type or earlier Not usable
––
PC/AT
SW0IX-GPPAE Usable Device range of A2ACPU A2US
SW IVD-GPPA
Usable Device range of A2UCPU A2US
MELSEC-MEDOC Usable Device range of A2ACPU A2US
A8PUE
–
Usable Device range of A2ACPU
A2U
(displayed at the start-up)
A7PU
A7PUS
–
Usable Device range of A3HCPU
A2U
(displayed at the start-up)
A6WU
Software version
"E" or later
Usable Device range of A2ACPU
–
Software version
"D" or earlier
Not usable
––
No.
Product used to write to the
CPU module
Product used to read from
the CPU module
Compatibility
1
Conventional product
(PLC: A3A start-up)
New Product
(PLC: A3A start-up)
• All the data are compatible.
2
New Product
(PLC: A3A start-up)
Conventional product
(PLC: A3A start-up)
3
Conventional product
(PLC: A3A start-up)
New Product
(PLC: A3U start-up)
• Because the PLC model names are different between in
writing and in reading, the following conditions are
identified.
1) If the verification is performed after reading, mismatch is
identified.
(The data can be used.)
2) Set values of the sampling trace/status latch (data stored
in the CPU module) will not be displayed.
3) When the network parameters are set to the new product,
they will not be displayed on the conventional product.
4
New Product
(PLC: A3U start-up)
Conventional product
(PLC: A3A start-up)

Mitsubishi MELSEC-A A2ASCPU-S1 Specifications

General

Brand	Mitsubishi
Model	MELSEC-A A2ASCPU-S1
Category	Controller
Language	English