Details of operation r -_
According to the room temperature when the operation
starts, the operation mode is automatically selected between ../
COOL and DRY. However, when operation is started again 1 __.....__
within 2 hours after the operation is stopped, the same "1 --
operation mode before it is stopped is selected.
operation mode selected first is not changed even if the Roomtemperature:
room temperature changes.If the operation mode does not About77_For higher --_COOL
match the room condition, select the required operation
mode by pressing the OMOOE button.
Details of "I FEEL..." auto operation
Room temperature Operation mode
when started
About77[F or higher ...... COOL ,
About77°Forlower DRY
Target temperature
(!n, lttal state)
About 75"F
I
Whentheroomtemperatureis 4"F higher than the set temperature, t.he set temperature may not be decreased I
since the unit operates at high power. In this case, wait until the room temperature drops to within 4"F of set
temperature.
Display details on the indoor unit
The operation indicator at the right side of
the indoor unit indicate the operation state.
I Operation Indicator I
11-n
Operation Indicator lamp
Difference between set
Indication Operation state temperatureandroom
temperature
This shows that the air conditioner is operating to reach the
"i[" "i'." target temperature. Wait for some time until the target About 4"F or more
temperature is obtained.
_i_" D This shows that the room temperature is approaching the About 4"F or less
target temperature.
• This unit is equipped with the auto restart function. When the main power is turned on, the air conditioner will start
•operation automatically in the same mode as set with the remote controller before the shutoff of main power.
I if the unit was set to off with the remote controller before the shutoff of main power, it will remain stopped
even after the main power is turned on.
[] If the unit was in the emergency operation before the shutoff of main power, it will start operation, at main
power on, in the same mode as set with the remote controller before the emergency operation.
[] Since the air conditioner has been shipped from the factory with the cooling mode saved in the memory for auto
restart function, it starts cooling operation when the user turns on the main power for the first time after installation.
10
To Next Page
Loading...
Need help?
General
