Handling of the remote controller
• The range that the signal can reach is about
6 m when pointed at the front of the indoor
unit.
• When the button is pressed, one or two
beeps will be heard from the indoor unit. If
no sound is heard, operate again.
• Use the remote controller carefully.
If it is dropped, thrown or gets wet, it may not
operate.
When installing on a wall, etc.
• Install it using the remote controller
installation case in a position where the
signal reception sound (beep) can be heard
from the indoor unit when the o_o_ ®button
is pressed,
i,j
How to install/remove the remote controller
Ilnstalling
I Insert the remote controller
I
downward.
LlrRem°vingl Pull it
up.
Remote controller
installationcase
Dry-cell batteries
IReference for replacing batteries i
When the signal does not operate the indoor
unit, or the display becomes dim, replace the
batteries with new alkaline batteries (size AAA).
• Replace 2 batteries with new batteries of the
same type.
• Do not use rechargeable batteries.
• To prevent from liquid leakage, take out all
batteries when the remote controller is not
going to be used for a long time.
• The service life of an alkaline battery is about
1 year.
However, since the recommended usable
time limit is indicated (month/year) on the
bottom of the battery, a battery the time limit
of which is approaching may become exhaust
sooner.
When the batteries of the remote controller run out
or remote controller malfunctions, EMERGENCY
OPERATION can be done using the EMERGENCY
OPERATION switch.
Press the EMERGENCY
OPERATION switch.
* Each time the switch is pressed, the unit
alternates between the EMERGENCY
COOL MODE and STOP MODE.
MS09NW
MS12NN,MS15NN,MS17NN
Details of operation are as shown below.
However, the temperature control does
not work for about 30 minutes at first
and the unit is set to the continuous
operation mode with the fan speed set
to "Medium".
F Operation Mode COOL_
Set temperature...... 75"F
........Fan speed .......... Medium
_.Horizontal vane Auto j
The operation mode is indicated on the
operation indicator lamp on the indoor
unit.
Operation Indicator Lamp
EMERGENCY COOL STOP
To stop EMERGENCY COOL
MODE, press EMERGENCY
OPERATION switch again.
8
To Next Page
Loading...
Need help?
General
