Features and controls
3-247
3
To pair
To pair a Bluetooth
®
device with the Bluetooth
®
2.0 interface,
follow the steps below.
1. Stop your vehicle in a safe area, put the selector lever in
the “P” (PARK) position and pull the parking brake lever.
OTE
● You cannot pair any Bluetooth
®
device with the
Bluetooth
®
2.0 interface unless the vehicle is parked.
Before pairing a Bluetooth
®
device with the Bluetooth
®
2.0 interface, confirm that the vehicle is parked in a safe
location.
2. Press the SPEECH button.
3. Say “Setup.”
4. Say “Pairing Options.”
5. The voice guide will say “Select one of the following:
pair, edit, delete, or list.” Say “Pair.”
OTE
● If 7 devices have already been paired, the voice guide will
say “Maximum devices paired” and then the system will
end the pairing process. To register a new device, delete
one device and then repeat the pairing process.
(Refer to “Selecting a device: Deleting a device” on page
3-248.)
6. The voice guide will say “Please say a 4-digit pairing
code.” Say a 4-digit number.
When the confirmation function is on, the system will
confirm whether the number said is acceptable. Answer
“Yes.”
Answer “No” to return to pairing code selection.
OTE
● Some Bluetooth
®
devices require a specific pairing code.
Please refer to the device manual for pairing code require-
ments.
● The pairing code entered here is only used for the
Bluetooth
®
connection certification. It is any 4-digit num-
ber the user would like to select.
Remember the pairing code as it needs to be keyed into
the Bluetooth
®
device later in the pairing process.
Depending on the connection settings of the Bluetooth
®
device, this code may have to be entered each time you
connect the Bluetooth
®
device to the Bluetooth
®
2.0
interface. For the default connection settings, refer to the
instructions for the device.
BK0150600US.book 247 ページ ２０１２年３月３０日 金曜日 午前１０時４３分
To Next Page
Loading...
Need help?
General
