3-246
Features and controls
3
6. When all enrollment commands have been read out, the
voice guide will say “Speaker enrollment is complete.”
The system will then end the speaker enrollment process
and return to the main menu.
OTE
● Completing the speaker enrollment process will turn on
the voice model automatically.
● The commands “Help” and “Cancel” will not work in this
mode.
Enabling and disabling the voice model and retraining
N00564900026
You can turn a voice model registered with the speaker enroll-
ment function on and off whenever you want.
You can also retrain the system.
Use the following procedure to perform these actions.
1. Press the SPEECH button.
2. Say “Voice training.”
3. If you have completed a speaker enrollment process once
already, the voice guide will say either “Enrollment is
enabled. Would you like to disable or retrain?” or “Enroll-
ment is disabled. Would you like to enable or retrain?”
4. When enrollment is “enabled,” the voice model is on;
when enrollment is “disabled,” the voice model is off. Say
the command that fits your needs.
Say “Retrain” to start the speaker enrollment process and
recreate a new voice model. (Refer to “Speaker enroll-
ment” on page 3-245.)
Connecting the Bluetooth
®
2.0 interface and
Bluetooth
®
device
N00565000154
Before you can make or receive hands-free calls or play music
using the Bluetooth
®
2.0 interface function, you must pair the
Bluetooth
®
device and Bluetooth
®
2.0 interface.
OTE
● Pairing is required only when the device is used for the
first time. Once the device has been paired with the
Bluetooth
®
2.0 interface, all you need is to bring the
device into the vehicle next time and the device will con-
nect to the Bluetooth
®
2.0 interface automatically (if sup-
ported by the device). The device must have Bluetooth
®
turned ON to connect.
Up to 7 Bluetooth
®
devices can be paired with the Bluetooth
®
2.0 interface.
If multiple paired Bluetooth
®
devices are available in the vehi-
cle, the cellular phone or music player most recently connected
is automatically connected to the Bluetooth
®
2.0 interface.
You can also change a Bluetooth
®
device to be connected.
BK0150600US.book 246 ページ ２０１２年３月３０日 金曜日 午前１０時４３分
To Next Page
Loading...
Need help?
General
