1. Displays the time until the next periodic
inspection.
NOTE
l
The distance is shown in units of 100 km
(100 miles). The time is shown in units of
months.
2. This informs you that a periodic inspec-
tion is due. Consult a MITSUBISHI
MOTORS Authorized Service Point.
At that time, when the ignition switch is
turned from the “LOCK” position to the
“ON” position or the operation mode is
changed from OFF to ON, the warning
display is displayed for a few seconds on
the information screen.
3. After your vehicle is inspected at a
MITSUBISHI MOTORS Authorized
Service Point, it displays the time until
the next periodic inspection.
To reset
The “---” display can be reset while the igni-
tion switch or the operation mode is in OFF.
When the display is reset, the time until the
next periodic inspection is displayed and the
warning display is no longer displayed when
the ignition switch is turned from the
“LOCK” position to the “ON” position or the
operation mode is changed from OFF to ON.
1. When you lightly press the multi infor-
mation display switch a few times, the
information display switches to the serv-
ice reminder display.
2. Press and hold the multi information dis-
play switch for about 2 seconds or more
to display “
” and make it flash. (If
there is no operation for about 10 sec-
onds with flashing, the display returns to
the previous screen.)
Multi information display - Type 1
5-10
OGFE16E1
Instruments and controls
5
To Next Page
Loading...
