CAUTION
l
When removing the tyre hanger from the
hook or hanging it back on the hook, hold
the tyre hanger carefully so that it does not
drop on your feet.
4. Install the tyre hanger installation bolt
cover.
To store the tools and jack
E00803800037
Reverse the removing procedure when stor-
ing the jack, jack bar and wheel nut wrench.
Refer to “Tools and jack” on page 8-05.
Wheel covers*
E00801300735
To remove
Wrap the tip of the jack bar with a cloth, in-
sert it into the notch provided in the wheel
cover, and pry the cover away from the
wheel. Using the same procedure at the other
wheel cover notches, work the wheel cover
away from the wheel to remove it complete-
ly.
CAUTION
l
Removing the cover with your hands may
cause injury to the fingers.
NOTE
l
The wheel cover is made of plastic. Pry it
loose carefully.
To install
1. Make sure the tabs (A) of the back of the
wheel cover are not broken and correctly
fitted on the rings (B). If in doubt, do not
install the wheel cover and consult your
MITSUBISHI MOTORS Authorized
Service Point.
2.
Align the air valve (C) of the tyre with
the notch (D) in the wheel cover.
How to change a tyre
8-13
OGFE16E1
For emergencies
8
To Next Page
Loading...
