Mitsubishi Outlander 2015 - Page 127

1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Changing the function set-
tings” on page 5-14.
2. Lightly press the multi information dis-
play switch to select “
” (temperature
unit setting).
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch in from °C to °F, or from °F to
°C.
The setting is changed to the selected
temperature unit.
NOTE
l
The temperature value on air conditioner
panel is switched in conjunction with outside
temperature display unit of the multi infor-
mation display.
However, “°C” or “°F” are not shown to
temperature display of an air conditioner.
l
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS), the
temperature value of the air conditioner
screen of MITSUBISHI Multi-Communica-
tion System (MMCS) is switched in con-
junction with outside temperature display
unit of the multi information display.
However, “°C” or “°F” are not shown to the
air conditioner screen.
Changing the display language
E00523200685
The language of the multi information dis-
play can be switched.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Changing the function set-
tings” on page 5-14.
2. Lightly press the multi information dis-
play switch to select “LANGUAGE”
(language setting).
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
to display “LANGUAGE”.
4. Lightly press the multi information dis-
play switch to select the desired lan-
guage.
5. If you hold down the multi information
display switch for about 2 seconds or
more, the setting is changed to the selec-
ted language.
NOTE
l
If “---” is selected in the language setting, a
warning message is not displayed when
there is a warning display or interrupt dis-
play.
Changing the language cooper-
ative control*
E00523301612
The language used in MITSUBISHI Multi-
Communication System (MMCS) (if so
equipped) or the Bluetooth
®
2.0 interface (if
so equipped) can be changed automatically to
the same language as that shown in the multi
information display.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Changing the function set-
tings” on page 5-14.
Multi information display - Type 1
5-17
OGFE16E1
Instruments and controls
5