[For vehicles equipped with the mirror re-
tractor switch]
Retracting and extending the
mirrors using the mirror re-
tractor switch
With the ignition switch in the “ON” or
“ACC” position or the operation mode in ON
or ACC, push the mirror retractor switch to
retract the mirrors. Push it again to extend the
mirrors to their original positions.
After placing the ignition switch in the
“LOCK” position or the operation mode in
OFF, it is possible to retract and extend the
mirrors using the mirror retractor switch for
about 30 seconds.
CAUTION
l
It is possible to retract and extend the mir-
rors by hand. After retracting a mirror using
the mirror retractor switch, however, you
should extend it by using the switch again,
not by hand. If you extended the mirror by
hand after retracting it using the switch, it
would not properly lock in position. As a re-
sult, it could move because of the wind or
vibration while you are driving, taking away
your rearward visibility.
NOTE
l
Be careful not to get your hands trapped
while a mirror is moving.
l
If you move a mirror by hand or it moves af-
ter hitting a person or object, you may not be
able to return it to its original position using
the mirror retractor switch. If this happens,
push the mirror retractor switch to place the
mirror in its retracted position and then push
the switch again to return the mirror to its
original position.
l
When freezing has occurred and mirrors fail
to operate as intended, please refrain from
repeated pushing of the retractor switch as
this action can result in burn-out of the mir-
ror motor circuits.
Retracting and extending the
mirrors without using the mir-
ror retractor switch
[Vehicles with keyless entry system]
The mirrors automatically retract or extend
when the doors are locked or unlocked using
the remote control switches of the keyless en-
try system.
Refer to “Keyless entry system: Operation of
the outside rear view mirrors” on page 3-05.
[Vehicles with keyless operation system]
The mirrors automatically retract or extend
when the doors are locked or unlocked using
the remote control switches or the keyless op-
eration function of the keyless operation sys-
tem.
Refer to “Keyless entry system: Operation of
the outside rear view mirrors” on page 3-05
or “Keyless operation system: To operate us-
ing the keyless operation function” on page
3-10.
NOTE
l
Functions can be modified as stated below.
Consult a MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
Outside rear-view mirrors
6-11
OGFE16E1
Starting and driving
6
To Next Page
Loading...
