NOTE
l
If you do not depress the brake pedal within
2 seconds after an automatic stop, you are
alerted to automatic cancellation of the ACC
by a buzzer and display message and the
ACC shifts into the ‘standby state’.
The vehicle will then start creeping as the
brakes are released.
CAUTION
l
Never leave the vehicle when it is stopped
by automatic braking.
When ACC no longer detects any vehicle in
front, a buzzer sounds and the symbol of ve-
hicle running ahead disappears from the
screen. The vehicle slowly accelerates to re-
sume the set speed and continues running at
that speed.
WARNING
l
Your vehicle may accelerate up to the set
speed in the following situations. Apply
the brake, if necessary, to slow down.
•
When your vehicle no longer follows
the vehicle in front, e.g. at a freeway ex-
it or when your vehicle or the vehicle in
front changes its lane.
•
When driving on a curve
l
If the vehicle in front turns off or changes
lane and another stationary vehicle is lo-
cated in front of that vehicle, the ACC
will not make deceleration control to the
stationary vehicle.
Proximity alarm
E00634701066
While the ACC is active, if your vehicle ap-
proaches too closely to a vehicle in front be-
cause the ACC cannot allow for an adequate
deceleration in such cases as rapid decelera-
tion of the vehicle in front or apparition of a
vehicle cutting in front of your vehicle, the
ACC gives a warning by sounding a buzzer
and displaying a message.
If this happens, increase the following dis-
tance by depressing the brake pedal or mak-
ing other decelerating control.
CAUTION
l
When the ACC is not in use, turn off the
system to prevent it from operating by mis-
take and an unexpected accident.
l
Never operate the ACC from outside the ve-
hicle.
Adaptive Cruise Control System (ACC)*
6-82
OGFE16E1
Starting and driving
6
To Next Page
Loading...
