EasyManuals Logo

Mitsubishi Outlander 2015 User Manual

Mitsubishi Outlander 2015
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #268 background imageLoading...
Page #268 background image
NOTE
When the selector lever is in positions
other than “D” (DRIVE) and “Ds”
(DOWNSHIFT & SPORTY DRIVING).
While the brake pedal is being depressed.
When the parking brake is engaged.
When the system determines that its per-
formance has been degraded due to con-
taminants adhered to the sensor.
When there is any abnormality in the sys-
tem.
To increase the set speed
There are two ways to increase the set speed.
By using the “RES +” switch:
The set speed increases by 1 km/h (1 mph)
every time you push up the “RES +” switch
while the ACC control is working. If you
hold the switch pushed up, the set speed in-
creases in 5 km/h (3 mph) increments.
NOTE
l
There is some time lag between the setting
to a new speed and actually accelerating to
that speed.
l
Speed setting operation is possible even in
presence of a vehicle in front. In this case,
however, the set speed alone increases with-
out actual acceleration taking place.
l
When the switch is held pushed, a buzzer
sounds every time the set speed changes.
CAUTION
l
The setting speed should be set up the suita-
ble speed according to a situation.
By using the accelerator pedal:
When the accelerator pedal is depressed
while driving with the ACC control working,
you can accelerate the vehicle temporarily
beyond the presently set speed.
At the point where the vehicle speed is raised
to your desired speed, push down and release
the “SET -” switch; the new speed is then set
in the system.
CAUTION
l
The ACC braking control and proximity
alarm functions will not work while the ac-
celerator pedal is depressed.
NOTE
l
The set speed indication on the display turns
to “---” when the accelerator pedal is de-
pressed. This indication remains as long as
the pedal is in a depressed position.
l
The ACC control at the original set speed re-
sumes as soon as you release the accelerator
pedal. Under certain conditions, however,
the braking control and alarming functions
of the ACC may not work for a short while
after releasing the accelerator pedal.
Adaptive Cruise Control System (ACC)*
6-86
OGFE16E1
Starting and driving
6

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Outlander 2015 and is the answer not in the manual?

Mitsubishi Outlander 2015 Specifications

General IconGeneral
BrandMitsubishi
ModelOutlander 2015
CategoryAutomobile
LanguageEnglish

Related product manuals