To pair
To pair a Bluetooth
®
device with the Blue-
tooth
®
2.0 interface, follow the steps below.
1. Stop your vehicle in a safe area, put the
gearshift lever (M/T) in the “N” (Neu-
tral) position, or the selector lever (A/T
or CVT) in the “P” (PARK) position,
and pull the parking brake lever.
NOTE
l
You cannot pair any Bluetooth
®
device with
the Bluetooth
®
2.0 interface unless the vehi-
cle is parked. Before pairing a Bluetooth
®
device with the Bluetooth
®
2.0 interface,
confirm that the vehicle is parked in a safe
location.
2. Press the SPEECH button.
3. Say “Setup”.
4. Say “Pairing options.”
5. The voice guide will say “Select one of
the following: pair, edit, delete, or list.”
Say “Pair.”
NOTE
l
If 7 devices have already been paired, the
voice guide will say “Maximum devices
paired” and then the system will end the
pairing process. To register a new device,
delete one device and then repeat the pairing
process.
(Refer to “Selecting a device: Deleting a de-
vice” on page 7-57.)
6. The voice guide will say “Please say a 4-
digit pairing code.” Say a 4-digit num-
ber.
When the confirmation function is on,
the system will confirm whether the
number said is acceptable. Answer
“Yes.”
Answer “No” to return to pairing code
selection.
NOTE
l
Some Bluetooth
®
devices require a specific
pairing code. Please refer to the device man-
ual for pairing code requirements.
NOTE
l
The pairing code entered here is only used
for the Bluetooth
®
connection certification.
It is any 4-digit number the user would like
to select.
Remember the pairing code as it needs to be
keyed into the Bluetooth
®
device later in the
pairing process.
Depending on the connection settings of the
Bluetooth
®
device, this code may have to be
entered each time you connect the Blue-
tooth
®
device to the Bluetooth
®
2.0 inter-
face. For the default connection settings, re-
fer to the instructions for the device.
7. The voice guide will say “Start pairing
procedure on the device. See the device
manual for instructions.” Enter in the
Bluetooth
®
device the 4-digit number
you have registered in Step 6.
NOTE
l
According to the corresponding device to
Bluetooth
®
, it might take a few minutes to
pair the Bluetooth
®
device with the Blue-
tooth
®
2.0 interface.
l
If the Bluetooth
®
2.0 interface cannot recog-
nize the Bluetooth
®
device, the voice guide
will say “Pairing has timed out” and the
pairing process will be cancelled.
Confirm that the device you are pairing sup-
ports Bluetooth
®
, and try pairing it again.
Bluetooth® 2.0 interface*
7-56
OGFE16E1
For pleasant driving
7
To Next Page
Loading...
