Mitsubishi Outlander 2015 User Manual

3. Pull the windscreen wiper and washer
switch towards you and hold it there.
(Since the ignition switch is in the
“LOCK” position or the operation mode
in OFF, washer fluid will not be
sprayed.)
4. After approximately 10 seconds, the
buzzer will make a sound. Keep the
windscreen wiper and washer switch
pulled towards you. (If the windscreen
wiper and washer switch was released,
the setting change mode would be can-
celled. To start over, perform the proce-
dure again from step 3.)
5. When the buzzer stops, with the wind-
screen wiper and washer switch still
pulled towards you, press the UNLOCK
switch (A) on the remote control switch
to select the security alarm settings
mode.
The settings mode can be toggled by
pressing the UNLOCK switch. The
mode can be confirmed from the num-
ber of times the buzzer sounds.
Number of
times the
buzzer
sounds
Security alarm settings
mode
1 Alarm inactive
2 Alarm active
6. Any of the following operations can be
used to terminate the system settings
change mode.
l
Releasing the windscreen wiper and
washer switch.
l
Closing the driver’s door.
l
Inserting the key into the ignition
switch. (vehicles with keyless entry
system)
l
Put the operation mode in ON or
ACC. (vehicles with the keyless oper-
ation system)
l
Placing the lamp switch in any posi-
tion other than “OFF”.
l
Allowing 30 seconds to pass without
making any changes to the settings.
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
l
Avoid leaving valuable items inside the ve-
hicle even when the security alarm system
has been set to the “active” mode.
Setting the system
E00301702132
Follow the procedure below to set the system
to the system armed mode.
1. Turn the ignition switch to the “LOCK”
position and then remove the key (vehi-
cles with keyless entry system), or put
the operation mode in OFF (vehicles
with keyless operation system).
2. Exit the vehicle and close all of the
doors, tailgate and bonnet.
3. Press the LOCK switch (A) on the re-
mote control switch of the keyless entry
system or the keyless operation system,
Security alarm system*
3-35
OGFE16E1
Locking and unlocking
3

Mitsubishi Outlander 2015 Specifications

General

Brand	Mitsubishi
Model	Outlander 2015
Category	Automobile
Language	English