3. Open the gap a little between the seat
cushion (A) and the seatback (B) with
your hand to locate the lower anchorages
(C).
4. For easier access, the seatback may be
recline rearward. Push the child restraint
system’s connectors (D) into the lower
anchorages (C) in accordance with the
instructions provided by the child re-
straint system’s manufacturer.
After it is security fastened, adjust the
seatback to 4 steps forward from most
reclined position.
A- Vehicle seat cushion
B- Vehicle seatback
C- Lower anchorage
D- Connector
If your child restraint system requires
the use of a tether strap, fasten the tether
strap in accordance with step 5.
5. Latch the tether strap hook (E) of the
child restraint system to the tether an-
chorage bar (F) and tighten the top tether
strap hook so it is securely fastened.
NOTE
l
If it is difficult to latch the tether strap hook,
turn the hook sideways.
6. Push and pull the child restraint system
in all directions to be sure it is secure.
To remove
Remove the child restraint system in accord-
ance with the instructions provided by the
child restraint system’s manufacturer.
Installing a child restraint sys-
tem to a 3-point type seat belt
(with emergency locking mech-
anism)
E00408701861
Installation:
1. Put a child restraint system on the seat in
which you wish to install it, and remove
the head restraint from the seat.
Refer to “Head restraints” on page 4-06.
2. Route the belt through the child restraint
according to the child restraint system
manufacturer’s instructions, then insert
the latch plate into the buckle.
3. Remove all slack of a lap belt by pulling
the webbing through the belt’s adjust-
ment feature.
3-point type seat belt requires no length
adjustment, remove all slack by using
the locking clip.
4. Before putting the child in the restraint,
push and pull the restraint in all direc-
tions to be sure it is secure. Do this be-
fore each use.
Child restraint
4-25
OGFE16E1
Seats and seat belts
4
To Next Page
Loading...
Need help?
General
