Mitsubishi OUTLANDER Owner's Manual

Indication lamps
E00501600100
Turn-signal indication lamps/
Hazard warning indication
lamps
E00501700358
These indication lamps blink in the fol-
lowing situations.
l
When the turn-signal lever is
moved to activate a turn-signal
lamp.
Refer to “Turn-signal lever” on
page 3-48.
l
When the hazard warning flasher
switch is pressed to activate the
hazard warning lamps.
Refer to “Hazard warning flasher
switch” on page 3-50.
l
When the hazard warning lamps
automatically activate due to sud-
den braking while driving.
Refer to “Emergency stop signal
system” on page 4-54.
NOTE
l
If these indication lamps blink too
fast due to any operation other
than sudden braking, the cause
may be a blown lamp bulb or a faul-
ty turn-signal connection.
High-beam indication lamp
E00501800173
This indication lamp illuminates when
the high-beam is used.
Front fog lamp indication
lamp*
E00501900350
This lamp illuminates while the front
fog lamps are on.
Rear fog lamp indication lamp
E00502000185
This lamp illuminates while the rear fog
lamp is on.
Position lamp indication lamp
E00508900173
This indication lamp illuminates while
the position lamps are on.
Adaptive Front lighting Sys-
tem (AFS) OFF indication
lamp*
E00525000010
This indication lamp illuminates when
the AFS is OFF.
ECO mode indicator*
E00529800032
Except for vehicles for Russia, Kazakh-
stan and Ukraine, this indicator will be
displayed when fuel-efficient driving is
achieved.
Diesel preheat indication lamp
(diesel-powered vehicles)
E00502300289
This indication lamp illuminates when
the ignition switch is placed in the “ON”
position. As the glow plug becomes hot,
the lamp goes out and the engine can be
started.
NOTE
l
If the engine is cold, the diesel pre-
heat indication lamp is on for a lon-
ger time.
l
On vehicles equipped with 4HK en-
gine, when the engine has not
been started within about 5 sec-
onds after the diesel preheat indi-
cation lamp went out, return the ig-
nition switch to the “LOCK” posi-
tion. Then, turn the switch to the
“ON” position to preheat the en-
gine again.
l
When the engine is warm, the die-
sel preheat indication lamp does
not come on even if the ignition
switch is placed in the “ON” posi-
tion.
Instruments and controls
3-37
3

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English