Mitsubishi OUTLANDER Owner's Manual

To reactivate the Auto Stop & Go (AS&G) system,
press the “Auto Stop & Go (AS&G) OFF” switch;
the display/indicator will turn off.
Type 2Type 1
NOTE
l
This display/indicator will also turn on for a
few seconds when the ignition switch is
turned to the “ON” position.
If the display/indicator blinks while
driving
E00627800068
If the “ ” display/indicator blinks, the Auto Stop
& Go (AS&G) system is malfunctioning and will
not operate.
We recommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
Manual transmission*
E00602000317
The shift pattern is shown on the gearshift lever
knob. Be sure to always fully depress the clutch ped-
al before attempting to shift the lever.
Vehicles with 5M/T Vehicles with 6M/T
CAUTION
l
Do not put the gearshift lever into the re-
verse position while the vehicle is moving
forward. Doing so could damage the trans-
mission.
l
Do not rest your foot on the clutch pedal
while driving. Doing so could cause rapid
wear to the clutch.
NOTE
l
If it is hard to shift into 1
st
, depress the
clutch pedal again; the shift will then be eas-
ier to make.
Moving the gearshift lever to the “R”
(Reverse) position
E00615400054
CAUTION
l
Do not move the gearshift lever to the
“R” (Reverse) position while the vehicle
is moving forward; doing so will damage
the transmission.
Vehicles equipped with 5M/T
To shift into the “R” (Reverse) position from 5
th
gear, move the gearshift lever to the “N” (Neutral)
position, and then move it to the “R” (Reverse) po-
sition.
Vehicles equipped with 6M/T
Pull up the pull-ring (A), then move the gearshift
lever to the “R” (Reverse) position with the pull-
ring still pulled.
Starting and driving
4-22
4

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English