Welcome light
E00528900368
This function turns on the position and tail lamps
for about 30 seconds after the UNLOCK switch
(A) on the remote control transmitter is pressed
when the combination headlamps and dipper
switch is in the “OFF” or “AUTO” position (for ve-
hicles equipped with the automatic lamp control).
On vehicles equipped with automatic lamp control,
the welcome light function will operate only when
it is dark outside the vehicle.
NOTE
l
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” po-
sition.
l
It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact
your MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make
the adjustment. Refer to the separate own-
er’s manual for details.
Coming home light
E00529000340
This function turns on the headlamps in the low
beam setting for about 30 seconds after the ignition
switch is turned to the “LOCK” position.
1. Turn the combination headlamps and dipper
switch to the “OFF” or “AUTO” position
(for vehicles equipped with the automatic
lamp control).
2. Turn the ignition switch to the “LOCK” posi-
tion. Also, if a key was used to start the en-
gine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition
switch to the “LOCK” position, pull the turn
signal lever towards you.
4. The headlamps will come on in the low-
beam setting for about 30 seconds. After the
headlamps go off, the headlamps can be
turned on again in the low beam setting for
about 30 seconds by pulling the turn signal
lever towards you within 60 seconds of turn-
ing the ignition switch to the “LOCK” posi-
tion. To turn on the headlamps again after 60
seconds of turning the ignition switch to the
“LOCK” position, repeat the process from
step 1.
Instruments and controls
3-45
3