Manual shift display
E00623500184
In manual shift, the currently selected gear is dis-
played on the multi-information display.
Warning display
E00626700204
or
When the warning display or the warning dis-
play appear on the information screen in the multi-
information display while you are driving, take the
following measures.
When warning display is showing
E00626800117
The temperature of the Twin Clutch SST fluid is
high.
If this occurs, take one of the following measures.
l
Reduce the vehicle speed.
l
Stop the vehicle in a safe place, place the gear-
shift lever in the “P” (PARK) position, and
then open the bonnet with the engine running
to cool the engine.
After a while, check that the warning display
has gone out. If the display goes out, the vehicle
can be driven normally. If the warning display re-
mains on or comes on frequently, have the vehicle
checked by a MITSUBISHI MOTORS Authorized
Service Point.
CAUTION
l
If the warning display is shown, such
as when the vehicle does not accelerate
while traveling even if the accelerator ped-
al is depressed, the vehicle may not be
able to be driven normally.
For safety, pay attention to your surround-
ings when driving the vehicle.
NOTE
l
If the vehicle is continuously driven on hilly
roads or in an aggressive manner involving
high engine rpm, sudden acceleration and/or
deceleration, the vehicle transmission may vi-
brate.
This vibration is to alert the driver that the
Twin Clutch SST fluid temperature has ris-
en. It does not indicate a malfunction.
If this occurs, perform the same measures for
when the warning appears. If the vibration
stops, the vehicle can be driven normally.
If vehicle is driven with warning displayed
If the vehicle continues to be driven after the
warning display appears, and the temperature of
the Twin Clutch SST fluid continues to rise, the
transmission protection control may operate and
cause the transmission to function as if the gear-
shift lever was in the “N” (NEUTRAL) position.
(At this time, the vehicle can temporarily not be
driven.)
If this occurs, take the following corrective meas-
ures:
1. Depress the brake pedal and stop the vehicle
in a safe place.
2. Place the gearshift lever in the “P” (PARK)
position, and then open the bonnet with the
engine running to cool the engine.
3.
After a while, check that the warning dis-
play has gone out, and then stop the engine if
the warning display has gone out.
4. If the engine can be restarted, the vehicle can
be driven normally.
If the warning display remains on or comes on fre-
quently, have the vehicle checked by a
MITSUBISHI MOTORS Authorized Service Point.
When warning display is showing
E00626900091
A safety device in the Twin Clutch SST has been
activated due to a possible malfunction in the Twin
Clutch SST or in the engine electronic control mod-
ule.
If this occurs, perform the following procedure.
1. Park your vehicle in a safe place and stop the
engine.
2. Restart the engine.
If the warning display goes out, there is no ab-
normal condition.
However, if the warning display remains on or
comes on frequently, have the vehicle checked by a
MITSUBISHI MOTORS Authorized Service Point
as soon as possible.
Starting and driving
4-43
4
To Next Page
Loading...
Need help?
General
