NOTE
l
Only when the gearshift lever or selector lev-
er is in the “R” position, the reversing sensor
system can be operated or be stopped by us-
ing the “SONAR” switch.
Warning for obstacles
If there is an obstacle behind the vehicle, a warning
will be issued with the information screen in the
multi-information display and a warning buzzer.
1- Corner sensor (left)
2- Back sensor
3- Corner sensor (right)
Corner sensor
Vehicle to obstacle dis-
tance
Warning display/sound
cycle
Approx. 60 to 40 cm Intermittent
Approx. 40 to 20 cm Fast intermittent
Within approx. 20 cm Continuous
Back sensor (vehicles without a towing bar)
Vehicle to obstacle dis-
tance
Warning display/sound
cycle
Approx. 150 to 80 cm Intermittent
Approx. 80 to 40 cm Fast intermittent
Within approx. 40 cm Continuous
Back sensor (vehicles with a towing bar)
Vehicle to obstacle dis-
tance
Warning display/sound
cycle
Approx. 150 to 100 cm Intermittent
Approx. 100 to 60 cm Fast intermittent
Within approx. 60 cm Continuous
CAUTION
l
The distances given are to be used for ref-
erence only, as errors may be caused by
various factors, such as temperature, hu-
midity, or the shape of the obstacles.
NOTE
l
When the sensors detect different obstacles
at the same time, the information screen in
the multi-information display indicates the di-
rections of the obstacles each sensor is detect-
ing. However, closer obstacles are given pri-
ority over other detected obstacles and the
warning buzzer sounds to inform you of clos-
er obstacles.
Changing the detection areas
E00615800159
The detection areas can be changed as follows:
Vehicles with a towing bar
While the operation of the system is stopped at the
“SONAR” switch, push the “SONAR” switch ap-
proximately 3 seconds or more, and release it. The
buzzer sounds twice to indicate that the detection
area has been changed.
Vehicles without a towing bar
While the operation of the system is stopped at the
“SONAR” switch, push the “SONAR” switch ap-
proximately 3 seconds or more, and release it. The
buzzer sounds once to indicate that the detection
area has been changed.
NOTE
l
The detection area will not change if you
keep the “SONAR” switch pushed for 10 sec-
onds or more.
l
After pushing the “SONAR” switch, revers-
ing sensor system operation differs accord-
ing to the detection area setting.
• Setting when towing bar is not equipped
When the gearshift lever or selector lever
is moved to the “R” position, the revers-
ing sensor system will operate even if cor-
ner sensor operation was stopped by push-
ing the “SONAR” switch.
Starting and driving
4-67
4
To Next Page
Loading...
Need help?
General
