Each time the door and tailgate unlock function is
set, a chime will sound to tell you the condition of
the door and tailgate unlock function.
Number of
chimes
Condition
One chime All doors and the tailgate unlock
Two chimes Driver’s door unlock only
1. Remove the key from the ignition switch.
2. Place the combination headlamps and dipper
switch in the “OFF” position, and leave the
driver’s door open.
3. Press the LOCK switch (1) for 4 to 10 sec-
onds and press the UNLOCK switch (2) dur-
ing this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of press-
ing the LOCK switch in step 3.
NOTE
l
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner’s man-
ual for details.
Procedure for replacing the remote
control switch battery
E00309500073
1. Remove the screw (A) from the remote con-
trol switch.
2. With the MITSUBISHI mark facing you, in-
sert the cloth covered tip of a straight blade
(or minus) screwdriver into the notch in the
remote control switch case and use it to open
the case.
NOTE
l
Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out.
3. Remove the remote control transmitter from
the remote control switch case. Then, open
the remote control transmitter using the meth-
od described in step 2.
4. Remove the old battery.
Locking and unlocking
1-06
1
To Next Page
Loading...
Need help?
General
