4. While holding down the tab (D), pull out the
socket (E).
5. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying thoroughly.
Headlamps (high-beam, except for ve-
hicles with high intensity discharge
headlamps)
E01009400148
1. When replacing the bulb on the right side of
the vehicle in the case of diesel-powered ve-
hicles equipped with M/T, remove the bolt
(A) holding down the washer tank spout and
move the spout towards the rear of the vehicle.
*: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
*: Front of the vehicle
Maintenance
8-26
8
To Next Page
Loading...
Need help?
General
