EasyManuals Logo

Mitsubishi OUTLANDER Owner's Manual

Mitsubishi OUTLANDER
434 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
3. Pull the windscreen wiper and washer switch
towards you and hold it there. (Since the igni-
tion switch is in the “LOCK” position, wash-
er fluid will not be sprayed.)
4. After approximately 10 seconds, the buzzer
will make a sound. Keep the windscreen wip-
er and washer switch pulled towards you. (If
the windscreen wiper and washer switch was
released, the setting change mode would be
cancelled. To start over, perform the proce-
dure again from step 3.)
5. When the buzzer stops, with the windscreen
wiper and washer switch still pulled towards
you, press the UNLOCK switch (A) on the re-
mote control switch to select the security
alarm settings mode.
Except for vehicles equipped with the keyless
operation system
Vehicles equipped with the keyless operation system
The settings mode can be toggled by press-
ing the UNLOCK switch. The mode can
be confirmed from the number of times
the buzzer sounds.
Number of
times the buz-
zer sounds
Security alarm settings mode
1 Alarm inactive
2 Alarm active
6. Any of the following operations can be used
to terminate the system settings change mode.
Releasing the windscreen wiper and
washer switch.
Closing the driver’s door.
Inserting the key into the ignition
switch.
The ignition switch is put into the
“LOCK”(PUSH OFF) position. (vehi-
cles equipped with the keyless opera-
tion system)
Placing the lamp switch in any posi-
tion other than “OFF”.
Allowing 30 seconds to pass without
making any changes to the settings.
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700734
Follow the procedure below to set the system to the
system armed mode.
1. Turn the ignition switch to the “LOCK” posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors, tail-
gate and bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver’s or
front passenger’s door lock/unlock switch
(B), or the tailgate LOCK switch (C) in order
to lock all the doors and the tailgate.
Locking and unlocking
1-37
1

Table of Contents

Other manuals for Mitsubishi OUTLANDER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi OUTLANDER and is the answer not in the manual?

Mitsubishi OUTLANDER Specifications

General IconGeneral
BrandMitsubishi
ModelOUTLANDER
CategoryAutomobile
LanguageEnglish

Related product manuals