To deactivate the vehicle inclination detection
function and the interior intrusion detection func-
tion
E00312100220
The vehicle inclination detection function and the
interior intrusion detection function can be deacti-
vated when parking in automated car parks, when
leaving pets in the vehicle or when leaving the ve-
hicle with the windows slightly open.
1. Turn the ignition switch to the “LOCK” posi-
tion.
Also, if a key was used to start the engine, re-
move the key from the ignition switch.
2. Raise and hold the wiper and washer switch
to the “MIST” position for approximately 3
seconds. The buzzer will sound once and the
function will be deactivated.
To activate the function again, raise and hold the
wiper and washer switch to the “MIST” position
for approximately 3 seconds.
The buzzer will sound twice and the function will
be activated.
NOTE
l
The function will be activated again if the fol-
lowing operation is performed.
• If the doors and the tailgate are unlocked
using the keyless entry system or the key-
less operation function.
• If the ignition switch is turned to the
“ON” or “ACC” position.
Cancelling the system
E00301800605
The following methods can be used to cancel the
system when it is in the system preparation mode
or the system armed mode.
l
Pressing the UNLOCK switch on the remote
control switch.
l
Turning the ignition switch to the “ON” posi-
tion.
l
Opening any one of the doors or the tailgate,
or inserting the key into the ignition switch
when the system is in the system preparation
mode.
l
Holding the keyless operation key and press-
ing the driver’s or front passenger’s door lock/
unlock switch, or the tailgate OPEN switch
to unlock the doors and the tailgate (vehicles
equipped with the keyless operation system).
NOTE
l
If the bonnet is opened during the system prep-
aration mode, the system preparation mode
is suspended.
The system returns to the system preparation
mode when the bonnet is closed.
l
If the battery terminals are disconnected
while the system is in the system preparation
mode, the memory will be erased.
l
It is possible to register up to 8 remote con-
trol switches for the keyless entry system
and 4 remote control switches for the keyless
operation system.
As long as they are registered, any of the re-
mote control switches, other than the one
used to activate the system, can be used to
cancel the system.
If you want to register additional remote con-
trol switches, please contact a MITSUBISHI
MOTORS Authorized Service Point.
l
The activation distance for the keyless entry
system is approximately 4 m.
If it is not possible to lock or unlock the vehi-
cle by pressing the switch at the correct dis-
tance or the security alarm system cannot be
set or cancelled using the switch, the battery
may need to be replaced.
Replace the battery at a MITSUBISHI
MOTORS Authorized Service Point.
l
If the UNLOCK switch on the remote con-
trol switch, or the driver’s or front passen-
ger’s door lock/unlock switch is pressed and
no door or the tailgate is opened within 30
seconds, the doors and the tailgate will auto-
matically relock. In this case as well, the sys-
tem preparation mode will go into effect.
l
The time between pressing the UNLOCK
switch on the remote control switch, or the
driver’s or front passenger’s door lock/un-
lock switch and automatic locking can be ad-
justed. Consult a MITSUBISHI MOTORS
Authorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner’s man-
ual for details.
Locking and unlocking
1-39
1
To Next Page
Loading...
Need help?
General
