WARNING
l
The seat belts must not be twisted when
worn.
3. Pull the belt slightly to adjust slackness as de-
sired.
To unfasten
Hold the latch plate and push the button on the buck-
le.
NOTE
l
As the belt retracts automatically, keep hold-
ing the latch plate while retracting so that the
belt stows slowly. Failure to do this could
damage the vehicle.
Driver’s seat belt warning lamp and
display
E00409800758
Warning lamp
Warning display type 1
Warning display type 2
A tone and warning lamp are used to remind the
driver to fasten the seat belt.
If the ignition switch is turned to the “ON” position
while a seat belt is not fastened, the warning lamp
comes on and the tone sounds for about 6 seconds
to remind the driver to fasten the seat belt.
If the vehicle is driven without fastening the seat
belt, approximately 1 minute after the ignition
switch is turned to the “ON” position, the warning
lamp comes on and flashes repeatedly, and the tone
sounds continuously. At the same time, the warn-
ing display is displayed on the information screen
in the multi-information display.
The warning lamp goes off and the tone stops after
approximately 90 seconds.
Subsequently, if the seat belt is still not fastened,
the warning lamp and tone will be activated to re-
mind the driver to fasten the seat belt whenever the
vehicle is stopped and started off again. The warn-
ing will operate in the same way if the seat belt is
removed while driving the vehicle. The warning
will stop when the seat belt is fastened.
Front passenger seat belt warning lamp
E00411600203
The front passenger seat belt warning lamp is loca-
ted on the instrument panel.
The lamp comes on when a person sits on the front
passenger seat but does not fasten the seat belt. It
goes off when the seat belt is subsequently fastened.
WARNING
l
Do not install any accessory or sticker
that makes the lamp difficult to see.
Seats and seat belts
2-20
2
To Next Page
Loading...
Need help?
General
