2. Push the child restraint system’s connectors
(A) into the slit (B) in accordance with the in-
structions provided by the child restraint sys-
tem’s manufacturer.
A- Connector
B- Slit
C- Vehicle seatback
D- Vehicle seat cushion
E- Lower anchorage
3. Remove the head restraint from the location
in which you wish to install a child restraint.
4. Latch the tether strap hook (F) of the child
seat to the tether anchorage bar (G) and tight-
en the top tether strap hook so it is securely
fastened.
5. Push and pull the child restraint in all direc-
tions to be sure it is secure.
To remove
Remove the child restraint in accordance with the
instructions provided by the child restraint sys-
tem’s manufacturer.
Installing a child restraint system to a
3-point type seat belt (with emergency
locking mechanism)
E00408700196
Installation:
1. Fasten the seat belt to secure the child re-
straint system. Make sure you hear a “click”
when you insert the latch plate in the buckle.
2. Use the locking clip to completely eliminate
any slackness.
3. Push and pull the child restraint in all direc-
tions to be sure it is secure.
Seats and seat belts
2-30
2
To Next Page
Loading...
Need help?
General
