Mitsubishi Q00JCPU - Page 614

9 - 40
9.3 Network Parameters
9
PARAMETERS
Table9.34 Network parameters Setting the CC-Link list (Continued)
Item Parameter No. Description Setting range Default value Reference
Special relay (SB)
CNM1
H Set the CC-Link parameters. Refer to the CC-Link Manual. ---- ----
Special register (SW)
Retry count
CNM2
H Set the CC-Link parameters. Refer to the CC-Link Manual. ---- ----
Automatic reconnection
station count
Standby master station
No.
PLC down select
Scan mode setting
Delay information setting
Station information
setting
Remote device station
initial setting
Interrupt settings