A - 3
[WIRING PRECAUTIONS]
CAUTION
The top surface of the module is covered with protective film to prevent
foreign objects such as cable offcuts from entering the module when wiring.
Do not remove this film until the wiring is complete.
Before operating the system, be sure to remove the film to provide
adequate ventilation.
Always place the thermocouple at least 100mm (3.94inch) away from the
main circuit cables and AC control lines. Fully keep it away from high-
voltage cables and circuits which include harmonics, such as an inverter's
load circuit. Not doing so will make the module more susceptible to noises,
surges and inductions.
REVISIONS
The manual number is given on the bottom right of the top cover.
Print Date
Manual Number Revision
Nov.
-0800155-A First edition
Jan.,2002 IB (NA)-0800155-B Model Q64TDV-GH was added.
Addition
Section2.2
Correction
About the Manuals, Chapter1,
Section2.1,Chapter4,Section5.1
Section5.2
ter6
This manual confers no industrial property rights or any rights of any other kind, nor
dose it confer any patent licenses. Mitsubishi Electric Corporation cannot be held
responsible for any problems involving industrial property rights which may occur as
a result of using the contents noted in this manual.
© 2000 MITSUBISHI ELECTRIC CORPORATION
To Next Page
Loading...
Need help?
General
