15 - 5
MELSEC-Q
15 TROUBLESHOOTING
[4] Invalid operations
For the following operations, the setting details will be invalidated, and an error or
warning will not occur.
•
Speed change during OPR
•
Speed change before operation
(Speed override change, skip command, continuous operation interruption
request, target position change request)
•
Axis stop during axis stop
•
Axis sudden stop during axis stop
•
Axis stop before axis operation
•
Axis sudden stop before axis operation
•
Writing to the buffer memory monitoring area
[5] Confirming the error and warning definitions
The error and warning definitions can be confirmed with the error and warning
codes. Confirming them requires GX Developer or GX Configurator-QP. For
details, refer to GX Developer Operating Manual or GX Configurator-QP
Operating Manual. (Refer to Sections 15.2 and 15.3 for details of the error and
warning codes.)
To Next Page
Loading...