Mitsubishi TG-2000A - System Configuration; System Configuration Example; Hardware Connection Diagram

5
3.1 System Configuration Example
3.2 Hardware Connection Diagram
(1) LAN connection
Connect the LAN cable to the personal computer. For the location of the LAN connector for the
personal computer, refer to the Instruction Manual of the personal computer.
3. System Configuration
Note:
• Be sure to use the hub.
• Execute the LAN cascade connection as shown below.
For 10BASE-T, the cascade connection is executable up to a maximum of 4 stages.
For 100BASE-T, the cascade connection is executable up to a maximum of 2 stages.
Remote
controller
Power
supply unit
Integrated software
TG-2000
HUB
G-50A
G-50A
LAN
Outdoor unit
Indoor unit
[Image drawing]
Power
supply u
nit
Integrated software
TG-2000
HUB
10BASE-T
straight cable
LAN
To G-50A