NetCommand TM Controlled Recordings
Record List Screen
(Figure 1)
To view a list of all of your currently programmed
recordings, select List from the Record/Connect
screen. A maximum of 8 scheduled recordings
are possible at a time. To cancel a recording on
the Record List, use ADJUST A or • to select the
recording, then press CANCEL.
Figure 1. Record List Screen
Restrictions for Traditional VCRs
If turned On, the TV must be viewing the source device.
• Your VCR must be connected to the A/V Receiver VCR
record outputs, or TV monitor outputs if you do not have
an A/V Receiver.
• The VCR must be set manually to "line input". Display
the Device Selection menu, highlight the VCR and press
GUIDE to change VCR inputs.
• If you are connected to an A/V Receiver, the A/V
Receiver must be turned on.
• To record directly from antenna or cable, connect the
TV "Loop Out" to the VCR "Antenna In."
• The TV can select channels on compatible cable boxes
for recordings. Leave the cable box turned on.
• If the AV Receiver, source device or recording device
cannot power On automatically, then leave those devices
powered On.
Cancel Current Recordings
To cancel a recording in progress, display the
Device Selection menu and highlight the source
of the recording. Confirm that the icon for VCR
(or recording device) is in the Connection Section
next to the TV icon. Press the CANCEL button.
The icon for the VCR (or recording device) will
disappear from the Connection Section to confirm
the cancellation.
Copy-Protected Material
When attempting to record copy-protected and
5C protected material, the Record functions of the
NetCommand TM and IEEE 1394 systems may be
prevented or stopped.
If one of the sub-channels in a bitstream is copy-
protected, then the entire bitstream, that is, all
programs for that bitstream or channel, are similarly
copy-protected. If you have a recording that is
tagged "Record Once", NetCommand TM will not
allow another copy to be made.
To Next Page
Loading...
Need help?
General
