Problem Possible Solution
• The REC button is not working, or, on the Transport
menu the record key is grayed out and not available.
• The device does not support recording, such as a DVD
player.
• Recordings can not be initiated from the Transport menu
when the device is an IEEE 1394 device. To record to
an IEEE 1394 device, change the TV to the ANT-DTV or
source device for the recording and press the REC key.
The Record menu displays allowing setup of a recording.
• There is no audio and video from the IEEE 1394 device.
• The device is not turned on - turn the device power on.
• No media (tape or disc) is inserted into the device.
• The media is blank (has no recording).
• The play command failed - Try pressing play again on the
device's remote control or front panel.
• The device is already in use (for example the device is
currently the recording).
• The source is copy-protected or violates copy-protection.
• The device's digital video signal is not supported by
the TV, such as DV video common with camcorders.
Use analog connections instead, if available.
• The device is not an audio/video device.
• Too many other devices are already communicating over
IEEE 1394. Remove or stop some devices and try
again.
• The IEEE 1394 device cannot be selected. • Both IEEE 1394 devices and Ant-DTV can not be
displayed in the PIE
• The device may be busy, either recording or a peer-to-
peer connection has been established. Cancel the
recording or peer-to-peer connection.
• The IEEE 1394 Device is not listed in the Device
Selection menu.
• The device is unchecked in the Review screen.
Go to Setup in the Main menu, select Edit NetCommand TM
Setup, then select Review. Verify the device is checked.
• The IEEE 1394 plug is disconnected or loose.
• The IEEE 1394 Device has not been powered On. Turn
on the device power.
• The device has not been discovered.
• The device is not an Audio/Video device.
To Next Page
Loading...
Need help?
General
