- 26 -
OPERATION
NOTE
◆ To enter the tolerance limit input mode, q it is necessary that data is not input
just after power on, or w all data is cleared by operation of the 'CL' key.
◆ In limit mode, limit data can changed by operation of the 'STAT' key. Maxi-
mum limit data of 5 is recorded. Reset limit data as necessary.
◆ When limit data is input by selecting the number of limit data already set, new
data is saved and old data removed.
◆ Limit data remains in memory even if the power is cut.
◆ Just after power ON, limit data used at the time of power cut are selected.
◆ When tolerance limit data is not necessary (when limit judgment is not
needed), select the limit number without limit data (refer to 3.2), or delete the
set limit data (refer to 3.3).
To Next Page
Loading...
Need help?
General