What to do if MKS Transducer shows overrange signal?
If your MKS Transducer shows an overrange positive or negative signal, it might be due to a shorted transducer or a damaged cable connecting the transducer to the electronics module. Check the supply voltages at the terminal block. Carefully examine the cable and transducer for any signs of damage. If you find any issues, replace the affected components.
Why MKS Transducer has unstable zero output?
An unstable zero output in your MKS Transducer might be caused by ambient temperature issues. The temperature may be too high, or it may be varying too much. Make sure the ambient temperature is within the product requirements as specified in Appendix A: Product Specifications, page 41.
What to do if MKS Baratron 627A measurement slowly goes positive?
If the measurement from your MKS Transducer slowly increases over time, it could be due to overpressure or contamination buildup in the P x cavity. You should return the transducer to MKS for servicing or replacement.
Warns against using specific compression fittings due to potential damage and voided warranty.
Prohibits unauthorized part substitution or modification, recommending factory service for repairs and maintenance.
Advises caution with hazardous materials, proper purging, and prohibits operation in explosive environments.
Emphasizes using correct fittings and following manufacturer instructions for assembly and tightening.
General| Type | Capacitance Manometer |
|---|---|
| Accuracy | ±0.25% of reading |
| Pressure Range | 0 to 1000 Torr |
| Output Signal | 0 to 10 VDC |
| Temperature Range | 0 to 50 °C |
| Operating Temperature | 0 to 50 °C |
| Power Supply | +15 VDC and -15 VDC |
| Pressure Connection | 1/4" VCR Male |
| Electrical Connection | 9-pin D-sub connector |
To Next Page
