Need help?Do you have a question about the MKS Baratron 631D and is the answer not in the manual?
General| Type | Capacitance manometer |
|---|---|
| Pressure Range | 0 to 1000 Torr |
| Accuracy | ±0.12% of reading |
| Output Signal | 0 to 10 VDC |
| Operating Temperature | 15 °C to 40 °C |
| Power Supply | 15 to 30 VDC |
| Materials Exposed to Process | Stainless Steel |
| Warm-up Time | 30 minutes |
Defines WARNING, CAUTION, and NOTE messages used in the manual.
Describes symbols that may appear on the unit itself, referencing IEC standards.
Details the process for checking and setting the zero adjustment for the transducer to ensure proper output.
Provides step-by-step instructions for adjusting the zero potentiometer to set the transducer output to zero.
Explains when and how to use the coarse zero switch if the zero potentiometer does not provide sufficient adjustment.
Covers adjusting trip point values using POTs, monitoring voltage, and the range of trip point signal voltage.
Defines how pressure changes (rising or falling) trigger the solid-state relays and mentions hysteresis.
Recommends regularly zeroing the unit, scheduling annual re-calibration, and periodic checks of cables and enclosure.
To Next Page
