@hello_mockingbird
6
Lay one Frame Leg back on its side and insert the Metal
Crossbar into the matching indent in the Frame Leg
above the Wooden Crossbar. Insert a Frame Bolt on
the outside of the leg and fully tighten until completely
snug.
Lay one Frame Leg back on its side and insert the
Adjustable Baby Footrest into the bottom of the white
track. Align the thumb screw at the bottom setting
and push the thumb screw into the track and tighten
until completely snug so there is no gap between the
Adjustable Baby Footrest and thumb screw.
Install the Metal Crossbar Install the Adjustable Baby Footrest
Important!
The thumb screws contain a spring and will pop out when not
fully engaged. Always check thumb screws are fully tightened
on both sides, on the same setting, before use. Tighten until
completely snug on both sides and there is no gap between
the Adjustable Baby Footrest and thumb screw.
The Footrest has four adjustable positions to fit your little
one just right. See page 16 for more tips about adjusting the
Footrest.
Pro Tip
Footrest umb Screw
Not Tightened
Fully Tightened
To Next Page
Loading...
Need help?
General