10
(2)
(4)
(4)
(4)
Step 5 – Mount the 9 pin miniature tube sockets
Drawing 3 shows where to mount the two 9 pin miniature
sockets. Make sure that pins 1 & 9 face away from the rear edge
of the chassis. (Use #4 hardware).
Step 6 – Mount the octal tube sockets and tube clips
Drawing 3 shows where to mount the two octal sockets along with their tube clips. Make sure that pins 1 & 8
face away from the rear edge of the chassis. (Use #6 hardware)
(2)
(4)(2)
(4)
(2)(2)
Use locking lugs in place of lock washers for the
mounting screws which face away from the rear
chassis edge.
The mounting holes of the tube clip are placed
over those of the octal socket. The screws are
then placed through both sets of mounting holes.
Step 7 – Mount both side handles
Mount both handles to the sides of the chassis box using their supplied #8 hardware. (Doing this step will
help you flip the chassis when mounting the two heavy transformers).
TOP
.25
"
Mount both side handles.
(4)
(4)
(2)
1
2
3
4
5
6
7
8
Chassis Rear
To Next Page
Loading...