T13 Wires
D
D will connect to T4.
(Make sure this wire has enough
length to get to about an inch past T4).
E will connect to T4.
(Make sure this wire has enough
length to get to about an inch past T4).
E
T14 Wires
T13
4"
D
E
5"
V3 cathode will connect to V3.
(Make sure this wire has enough
length to get to about V4).
V3 cathode
T14
V3
cathode
13"
18
SECTION 6 – Connect the Front Mounted Components
Please refer to Drawings 13 - 17.
Step 1 – Connect the Potentiometers and Input Jack
Drawing 13 shows where to connect each pot.
A) Connect the cold lug of the Bass pot to T5 terminal 1.
cold
wiper
hot
B) Connect Bass wiper to the Treble cold (do not solder the treble cold side, yet).
C) Connect Treble cold to T5 terminal 4 (now solder the treble cold side).
D) Connect Treble wiper to Volume hot.
E) Connect Treble hot to T5 terminal 6.
F) Connect Volume cold to Input Jack ground pin
(do not solder the jack ground side, yet).
ground
switch
signal
G) Connect Volume wiper to V1 pin 7.
H) Mount but do not solder a 1MΩ, ½ W resistor from Input Jack switch pin to
signal pin.
I) Connect a jumper wire from Input Jack ground pin to switch pin and solder this
connection.
J) Connect Input Jack signal pin to T2 terminal 4.
1
4
T2
1
6
T5
Notice the following sub-step letters (A, B, C, etc.) are
shown on the Assembly drawings in parenthesis.
To Next Page
Loading...