25
Step 2 – Connect the Power Cord Wires
Drawing 22 shows where to connect the wires.
T9
1 2 3
A) Connect the Power Cord black wire to T9 terminal 1
(now solder this connection).
B) Connect the Power Cord green wire to T9 terminal 2.
C) Connect the Power Cord white wire to T9 terminal 3
(now solder this connection).
SECTION 12 – Fasten the Rubber Feet to the Chassis Cover
(4)(4)
(4)
Use the #8 screws and #8 nuts to fasten the four rubber feet to
their mounting holes on the chassis cover.
SECTION 13 – Fasten the Chassis Cover to the Chassis Box
(4)
1
Use the #8 self-tapping screws to fasten the chassis cover to the
chassis box.
You will have to use a lot of force
to initially insert the self tapping
screws.
To Next Page
Loading...