STEP BY STEP ASSEMBLY
Please refer to the respective drawings for each section. We recommend browsing over the instructions and
looking at all drawings once before actually beginning to assemble the kit.
HARDWARE FASTENING TIP
When fastening components with mounting hardware (screws, lock washers, and hex nuts), the lock washer and
hex nuts should be fastened on the other side of the chassis from the head of the screw in the order pictured
below.
SECTION 1 – Mounting of Top Components
Please refer to Drawings 1 – 6.
Find your chassis box. Drawing 1 identifies the names of
components that you will be mounting to the top of the
chassis box.
COLD
HOT
Step 2
Drawing 2 shows where to stick the bias label. Make sure to line up the hole in the
sticker with the hole in the chassis box.
Step 3 – Mount the bias pot
Drawing 3 shows where to mount the bias pot. Bend down the tab on the top of
the pot for a better fit against the chassis top. Make sure the solder lugs of the pot
are directed toward the front of the chassis. (Turn the shaft all the way to cold).
25KL
Chassis Front
Bent back mounting tab
Step 4 – Mount the rubber grommets
Drawing 3 shows where to mount the five rubber grommets. Squeeze the grommet
into the hole and push it into place with your fingers.
9
Chassis
Screw Head
Lock Washer Hex Nut
Component Mounting
Bracket
(5)
Step 1
Use a fine cut miniature round file to very lightly file away
the paint coating only from the inside edge of each chassis
hole.
(The chassis provides the ground connection for many
components so it is important that the inner edge of
these holes are not insulated by the paint coating).
To Next Page
Loading...