English 26
Connecting the water and electricity sources
Connecting to the water source and the power source must be performed by a qualified
technician.
Make sure the unit is installed above the water hose or power cord.
The unit must be connected to a water source using a new pipe. Do not use old pipe.
Connecting the water inlet hose
Connect the cold water hose with a threaded connector to
(3/4 inch) and make sure it is properly installed and tight. If
the drains are new or unused for long periods of time, then
turn on the water first until the channel is clean, it aims to
avoid blockage and damage to the unit caused by dirty
water.
Connect the water outlet hose (drain hose)
Attach the drain hose of the unit to pipe / home sewer, make
sure it is not bent or pinch.
If the hose length is not long enough, then use additional
hose with the same materials and quality. It must be
remembered that the length of the hose should not more
than 4 meter connection either with or without a connection.
If the drain hose is more than 4 meters it could lead to the
plates and other tableware washed less clean. Make sure the
drain hose is properly installed and secured in the plumbing/
sewer.
Connecting to the power source
Before installing the power cord to the power source, make sure that:
- The power outlet is at ground / earth with the appropriate current.
- The power outlet can hold a maximum load of unit.
- The power outlet is appropriate with the mains unit, if it does not fit contact a qualified technician to
replace it. Do not use a cable connector or socket along with the other unit.
- Once the unit is installed, the power cords and plugs should be easy accessible.
- Make sure the cable is not bent or pinched.
- If the power cord is damage it must be replaced with a cable that has the same qualifications,
contact a technician for installation, this is to avoid the danger that can be caused.
- The Company is not responsible for any accidents caused because of not following these
instructions.
To Next Page
Loading...