Modena WP 600 - Running Wash Programs and Starting Cycles

English 36
At the end of the washing program
When the wash cycle has stopped, buzzer / alarm will sound 6 times, then stopped. Turn off the unit
by pressing the On / Off button, turn off the water supply and open the door of the machine. Wait for a
few minutes before removing tableware, so that the tableware will be cold and the dryer would be
better. Hot plates can easily broken. Therefore allow it to cool before take them out. Empty the lower
basket first and then the upper basket, this will prevent water droplets from the basket override the
plates under the basket.
When the washing program has finished, it is recommended to remove the dishwasher plug
and turn off the water faucet.
F. Run a wash program
Table of washing cycle
Program
Specification
Cycle
Detergent
Pre / Main
Time
(min)
Energy
(kWh)
Water
(L)
Intensive
Washing program for
heavily dirty
tableware such as the
pan, tableware with
lids, cutlery and
tableware with dried
food stains.
Pre-wash
Rinse
Main wash
(60
o
C)
Hot Rinse
Drying
5/25g
168
1.30
14
*Normal
Daily washing cycle
for equipment with a
normal amount of
impurities such as
pans, glasses etc.
Pre-wash
Rinse
Main wash
(50
o
C)
Hot Rinse
Drying
5/25g
153
1.05
14
Eco
For equipment with
light dirty such as
plates, cups, bowls
and pan that are not
too dirty.
Pre-wash
Main wash
(45
o
C)
Hot Rinse
Drying
5/25g
123
0.85
11
Crystal
Economical and
quick wash program
for appliances that
are susceptible to
high temperatures.
Pre-wash
Main wash
(40
o
C)
Hot Rinse
Drying
5/25g
126
0.80
11
Rapid
quick washing for the
cutlery with the level
of light dirty and no
need to dry it.
Main wash
(40
o
C)
Hot Rinse
5/25g
37
0.50
7
Pre-Rinse
For the cutlery to be
washed / cleaned
later.
Pre-wash
8
0.01
4
*This program at the time of testing, information for comparative testing accordance with the program as below:
- Capacity: 12 setting.
- The position of the basket on the low position.
- Rinse aid setting at level 5.
Starting a wash cycle
Pull out the bottom and upper basket, then place a plate and cutlery on the basket and insert the
basket into the machine.
3. It is advisable to fill in the bottom of the basket first and then the upper basket (see section "FILL
IN DISHWASHER BASKET"), fill the detergent in place (see section "salt, rinse aid and
detergent").
4. Insert the power cord into the wall socket. Required power supply is 220V-240V AC 50 HZ, the
specification of the outlet is 12 A 250 V AC 50HZ. Make sure the water supply has been opened
with the maximum pressure. Close the door, press the ON / OFF button, press the "program" to
select the "wash cycle". (see "Table of washing cycles".). Make sure the door has completely
closed.