EasyManua.ls Logo

MODSTER MINI BLIZZARD PRO - Warranty & Legal Information; Disclaimer of Warranty; Operating Safety Rules

MODSTER MINI BLIZZARD PRO
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
F
Manual Mini Blizzard Pro
www.modster.at 23
Problem Possible Cause Solution
The drone
does not respond
1. the battery is empty 1. charge the battery
2. The remote control battery is low and
the voltage indicator is ashing
2. replace the
Remote control battery
3. the binding process between
and the drone was not successful
3. perform the binding process again
again
The drone reacts
inaccurately to
control
1. The battery of the remote control is
weak or of poor quality
1. Replace the old battery with a new
one
2. another remote control or WLAN inter-
feres with the transmission
2. change the ight area
The drone drifts
sideways while
hovering
1. No horizontal position correction 1. Remote Control and perform the
calibration again.
Disclaimer of warranty
Only for children 14 years and older
Product contains small parts that can be swallowed
Keep hands, face, hair and loose clothing away from rotors
Do not reach into rotating parts
Always disconnect battery plug and remove battery from model after ight!
Fly only where it is safe and you do not endanger third parties
Keep the operating instructions and read them carefully before use.
We recommend that persons with no knowledge of model ying operate the model under the gui-
dance of an experienced pilot
Before each ight, test the range of the remote control, as well as the battery charge level and check
batteries or accumulators in the remote control.
Do not y...
near crowds of people,
towards people or animals,
in poor visibility,
in the vicinity of high-voltage power lines or radio masts
during thunderstorms, in rain, snow or damp conditions.
1. Always keep the aircraft in sight and under control.
2. Always use fully charged batteries.
3. Always turn on model rst, then transmitter, and always turn o model rst, then transmitter.
4. Do not use the model if it shows visual or mechanical damage.
5. Always check all screw connections and structures for tightness and damage.
6. Never reach into the rotating rotor - risk of injury!
7. Always disconnect and/or remove the ight battery from the model after ight.
8. Always charge the battery outside the model, charge on a non-combustible surface, never store the
battery inside the model.
Never charge batteries unattended!
Inform yourself about the legal regulations valid in your country.