F
Manual Mini Blizzard Pro
16 www.modster.at
Flying
Start method 1:
Make sure that the propellers are correctly mounted and tightened.
1. Switch on the device
and place it on a at
surface.
1. Place the drone on a at surface. Move the two control sticks to the
apparent position. After 2-3 seconds, the LED will ash rapidly. The
calibration was successful if the LED lights up constantly after
2-3 seconds.
2. Switch on the remote
control.
2. Move the two control sticks as shown in the gure to start the motors.
3. Move the left control
stick forward, then back
to bind the drone &
transmitter.
3. Move the left control stick forward, the drone will take o.
Landing method 1:
Landing method 2:
Landing method 3:
Start method 2:
To Next Page
Loading...