modway MOD-5469 User Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
MOD-5469 QUEEN BED FRAME
Hardware:
Component:
A
Bolt M8x25mm x16
B
C
Bolt M8x20mm x4
D
Allen Wrench M5 x1
1
Long Board x2
Thank you for purchasing the MODWAY QUEEN BED FRAME！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed frame, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
Bolt M8x35mm x4
E
Open Wrench x1
F
Side Plastic Cover x26
2
Short Board x2
3
Leg x4
5
Support Leg x2
3
4
Stretcher x1
6
Slat x26
G
Center Plastic Cover x13
H
Nut M8 x4
1
1
2
2
3
3
3
5
4

modway MOD-5469 Specifications

General

Model	MOD-5469
Weight Capacity	331 lbs
Assembly Required	Yes
Seat Height	18"
Product Type	Chair
Material	Metal
Dimensions	31.5" H
Product Category	Chair

Summary

Helpful Advice and Product Overview

Pre-Assembly Advice

Provides essential tips and recommendations before starting the bed frame assembly process.

Hardware Identification

Lists and identifies all necessary hardware components for assembling the bed frame.

Bed Frame Components Identification

Lists and identifies all major parts of the queen bed frame, including boards, legs, and slats.

Assembly Instructions

Step 1: Initial Frame Setup

Place Long Boards (1), Short Boards (2), and Legs (3) upside down and connect them as shown.

Step 2: Secure Boards to Legs

Insert and tighten Bolts (A) into pre-drilled holes connecting boards to legs using Allen Wrench (D).

Step 3: Attach Stretchers and Support Legs

Secure Stretchers (4) with Bolts (C) and Support Legs (5) with Bolts (B) and Nuts (H).

Step 4: Install Slats and Covers

Insert Slats (6) into plastic covers (F, G) and attach them to the frame's boards and rails.