- 17 -
This is the amount of time the mower will be active. This includes charging time. For
example: if set to 8 hours and the mower is set to operate from 8:00pm it will operate
until 4:00am. In this time it may mow for 1 hour charge for 2 hours mow again for 1 hour;
charge for 2 hours, mow for one hours and return to charge ready for the next cycle.
1. Press OK button to enter sub-menu 1.
2. Select ‘
setting’ to enter sub-menu 2.
3. Select ‘work time’.
4. Set work time by UP and DOWN buttons. (default is 8hrs)
5. Press OK button to confirm setting.
1. Press the STOP button.
2. The mower stops immediately and the
control panel hatch opens.
3. The screen shows ‘emergency stop’
4. Press OK or RETURN button.
5. Enter the PIN code
6. If the mower was running when the
STOP button was pressed, the screen
will show ‘continue to work?’. You can
then either press OK to continue the
task, or press RETURN to cancel it.
1. Press HOME button for 3 seconds.
2. Close the cover and mower will return
to station for charging.
Work time setting
You may want to stop the mower during its cutting cycle. To do this:
Stop Back to station
To Next Page
Loading...