MoeBot S5 - PIN and System Management; PIN Code Operations; Factory Reset and Error Log

- 21 -
1.
PIN code should be entered after power-
ing on, pressing STOP button, and before
clearing error status and changing PIN
code.
2.If the PIN code is incorrect, the screen
will show “PIN wrong, please retry’.
3.If the PIN code is entered incorrectly 3
times, the screen will be locked for 15
seconds. The lock time will double for
further incorrect entries.
1. Press OK
button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘change PIN’.
4. Enter the original PIN code.
5. Enter new PIN code.
6. Enter the new PIN code again. (‘New
passwords do not match’ will be shown for
inconsistent passwords.)
7. Press OK button to confirm.
1. Press OK
button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘factory reset’.
4. The screen shows ‘Reset to factory
mode?’
5. Press OK button to confirm.
1. Press OK button to enter sub-menu 1.
2. Select ‘setting’ to enter sub-menu 2.
3. Select ‘information’ to enter sub-menu 3.
4. Select ‘error log’.
5. The past 10 records (including date,
time and error message) will be shown.
In the event of malfunction the error log will record all actions and can be used for
service maintenance and fault finding.
PIN code Change PIN code
Factory reset Error log