Moen 1255 - Reassembly; Spout Reinstallation; Crown Ring Reinstallation; Final Check

4
Use a soft brush to
clean the inside of
the spout. Insure
the inner surface is
clean and smooth.
Slide the spout
back on until it is
flush with the base.
Secure the crown ring
into the top of the spout
so the tabs of the tuck
under the edge of the
channel. The line
highlighted in orange
shows where the gap in
the crown ring should
be located.
To insure the crown
ring is seated
properly, gently pull
upwards on the spout.
If the crown ring is
seated, the spout will
not lift off.
To reassemble the
handle: Work
backwards from
steps 3 through 1.
Once the handle is assembled, you are all done!