To Next PageTo Next Page
Need help?Do you have a question about the Monacor PA-312 and is the answer not in the manual?
Covers indoor use, protection from liquids, handling damage, proper disconnection, cleaning, and warranty/disposal.
Warns about dangerous mains voltage and high voltage at speaker terminals during operation.
Describes the amplifier's design for PA systems and its six input types for various audio sources.
Instructions for mounting the amplifier in a rack, including ventilation and securing the unit.
Details the controls, indicators, and inputs/outputs located on the front of the amplifier.
Explains the various input/output terminals and connectors on the rear of the amplifier.
Covers indoor use, protection from liquids, handling damage, proper disconnection, cleaning, and warranty/disposal.
Warns about dangerous mains voltage and high voltage at speaker terminals during operation.
Describes the amplifier's design for PA systems and its six input types for various audio sources.
Instructions for mounting the amplifier in a rack, including ventilation and securing the unit.
Details the controls, indicators, and inputs/outputs located on the front of the amplifier.
Explains the various input/output terminals and connectors on the rear of the amplifier.
General| Power Output | 120 W |
|---|---|
| Input Impedance | 10 kΩ |
| Frequency Response | 20 Hz - 20 kHz |
| Input Sensitivity | 0.775 V |
| Signal-to-Noise Ratio | > 75 dB |
| Outputs | Speakon, Binding Posts |
| Power Supply | 230 V AC, 50 Hz |
| Damping Factor | > 200 |
| Inputs | 6.3mm jack (mic), RCA (line) |
