9
English
5.3 Priority Switch
A priority switch (NO contact) can be connected
to the screw terminals PRIORITY (9). Channels
MIC 2, PHONO and AUX are faded out while this
priority switch is pressed so that only an nounce-
ments via MIC 1 can be heard. After releasing the
priority switch, channels MIC 2, PHONO and AUX
are faded in again.
5.4 Power supply
1) Finally, connect the amplifier by means of the
mains cable(8) to a mains socket (230 V/50 Hz).
2) To ensure continued operation of the amplifier
in case of a mains failure, connect an emer-
gency power supply unit (e. g. PA-24ESP from
MONACOR) to the terminals 12 – 24 V⎓ (12).
Note: If the voltage from the emergency power sup-
ply unit is present at the terminals 12 – 24 V⎓, the
amplifier cannot be switched off with the switch
POWER (6). In case of a mains failure or if it is
switched off, the amplifier will switch automatically
to the emergency power supply.
6 Operation
1)
Turn the control for the total volume (5) to zero
before switching on. Switch on the amplifier via
the POWER switch (6).
2)
Slightly turn up the control for the total vol-
ume(5). Adjust the desired volume in relation
to each other via the controls MIC 1, MIC 2 (1),
PHONO (2) and AUX (3). Set all controls which
are not connected to a source to zero.
3) Adjust the tone with the controls (4) BASS and
TREBLE and the volume with the control for the
total volume (5).
4)
If desired, fade the microphones in and out
with the controls MIC 1 and MIC 2 (1) as well
as the music sources with the controls PHONO
(2) and AUX (3).
5)
If a priority switch for microphone MIC 1 is con-
nected, keep it pressed during announcements.
Channels MIC 2, PHONO and AUX will be faded
out and only the announcement will be heard.
After releasing the priority switch, channels
MIC 2, PHONO and AUX will be faded in again.
7 Specifications
Total output power: . . . . . . 70 W
Rated power: . . . . . . . . . . . 35 W
THD: . . . . . . . . . . . . . . . . . . < 1 %
Outputs
Speakers: . . . . . . . . . . . . 4 / 8 Ω, 70 / 100 V
Inputs
2 × MIC: . . . . . . . . . . . . . 5 mV
1 × PHONO: . . . . . . . . . . 5 mV (RIAA)
1 × AUX: . . . . . . . . . . . . . 210 mV
Frequency range: . . . . . . . . 100 – 18 000 Hz
S / N ratio: . . . . . . . . . . . . . . > 55 dB
Power supply
mains voltage: . . . . . . . . . 230 V/ 50 Hz
power consumption: . . . . 100 VA max.
emergency power supply: ⎓ 12 – 24 V/ 2.5 A
Ambient temperature: . . . . 0 – 40 °C
Dimensions (W × H × D): . . 320 × 85 × 230 mm
Weight: . . . . . . . . . . . . . . . 4.3 kg
Connections
MIC 1 and 2: . . . . . . . . . . 6,3 mm jack
AUX and Phono: . . . . . . . RCA L / R
Speakers: . . . . . . . . . . . . screw terminals
Subject to technical modification.
All rights reserved by MONACOR
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
reproduced in any form or by any means for any commercial use.
To Next Page
Loading...
Need help?
General
