Monarch 9416 XL - Loading Labels for Peel Mode - Part 1; Peel Mode Label Loading Preparation

12
Loading Labels for Peel Mode
Peel mode separates the label from the backing paper while printing.
1. Press the release levers towards the front of the printer to
release the cover or supply door.
2. Lift open the cover or supply door.
For thermal transfer printers, the supply door support at the
right-hand rear of the printer holds the supply door open.
3. Pull out the peel door located on the front of the printer to
display the peel roller and the peel bar.
4. Remove the supply holder guide from one end of the supply
holder. (The supply holder is normally attached with a line to
the inside of the printer. Do not cut the line.)
5. Slide a roll of labels onto the supply holder.
6. Place the supply holder guide back onto the end of the supply
holder. If you are using the supply core adapters for 1.5-inch
core supply, make sure to push the supply core adapters into
the ends of the supply.
Supply Holder Guides
Peel Roller
Peel Door
Peel Bar